Click on the top left button to switch.
Distorsion amount applies to Disto Mode.
Gate and Amount applies to Fuzz Mode.
Reverb runs from 0 to 1000 ms, and is cut at 0 ms.
Drive runs from 0 to 10. Value at 1 means neutral drive.
Filter Slider : a Lowpass filter from 20 Hz to 20 kHz allows you to cut high frequencies.
Volume Mixer : amount of distorsion into the mix.
Solo : be careful with the volume level before clicking !
No distorsion here, only fuzz.
Octave runs from -4 to +4 (-48 semitones to +48 semitones).
Gate and Amount applies to Fuzz.
Reverb runs from 0 to 1000 ms, and is cut at 0 ms.
Drive runs from 0 to 10. Value at 1 means neutral drive.
Filter Slider : a Lowpass filter from 20 Hz to 20 kHz allows you to cut high frequencies.
Volume Mixer : amount of distorsion into the mix.
Solo : be careful with the volume level before clicking !
This module sends and amount of OCTA HARD signal into ZYNTH. The signal doesn’t pass trough the general mix, to monitor what is send you can click on the Solo button (for your hears and your audio system take care of the volume level !).
Delay runs from 0 to 1000 ms and is made to create messy feedbacks to be send to ZYNTH.
Filter Slider : a Bandpass filter from 20 Hz to 20 kHz allows you to filter a selected frequency band.
This module use the retune~ object from Max 7 to track the pitch from the audio input and to use it into a synth.
Gain in : adjust in function of your audio input.
Smooth : smooth the pitch tracking from 0 to 500 ms.
Three oscillators are available, with 4 waveforms (Sin, Saw, Tri, Square), that you can mix together and pitch thtrough Octave knobs.
Filter Sliders : a Lowpass and Hipass filters from 20 Hz to 20 kHz allows you choose between cuting high or low frequencies.
When using injection from OCTA HARD, the Gain In can be used to balance the mix between signal coming from audio input and signal from OCTA HARD.